Sentinel
Member
Right so I put new clutch plates in and a new bearing clutch assembly. Runs fine. But I got it back from my mechanic due to some electrical issues, and they re tuned it again although it wasn't proper.
When I twist the throttle, it's ok but doesn't snap back after you've given it gas. It just slowly goes back or sits in place until you fully untwist it.
Also when I do give throttle, my bike doesn't, accelerate like it used to. Could this be carb related because I fine tuned it myself and it was way too much gas. I will give throttle but when it's mid throttle all it does is make noise and you can hear the high rpms. It doesn't GO.
What could be the cause of this?
When I twist the throttle, it's ok but doesn't snap back after you've given it gas. It just slowly goes back or sits in place until you fully untwist it.
Also when I do give throttle, my bike doesn't, accelerate like it used to. Could this be carb related because I fine tuned it myself and it was way too much gas. I will give throttle but when it's mid throttle all it does is make noise and you can hear the high rpms. It doesn't GO.
What could be the cause of this?