Tomorrow I am finally going to start on the roller chain conversion for my bike. I have done alot of reading on this site and have a pretty good idea of how to do it. One question I have is what is a good type of assembly lube to use and where exactly do I apply it? everything?
I am also concerned about oil pressure during initial startup. I know some guys turn the engine over with the plugs out to build pressure. I've read that you need to ground the wires while doing this. To ground the wires do you insert the plug into the wire and have that touching the motor? or do you have to ground it some other way?
I'm sure I will have a few more questions over the next couple of days but i'm really looking forward to the project.
I am also concerned about oil pressure during initial startup. I know some guys turn the engine over with the plugs out to build pressure. I've read that you need to ground the wires while doing this. To ground the wires do you insert the plug into the wire and have that touching the motor? or do you have to ground it some other way?
I'm sure I will have a few more questions over the next couple of days but i'm really looking forward to the project.