Redfish-Joe
Senior Member
Got my new Heritage bars yesterday and installed them today on my Road Glide. Well worth the trouble to do it.
A little tip to those who are thinking about it. I read a few post about the trouble some have had getting the throttle wires thru the bars. Take a piece of fishing line and tie a small nut to it. Drop it thru your bars and remove the nut. Tie and tape it to the wires. This will help pull the wires thru as you also push them. It should take very litt effort to pull the wires thru. If it gets hard to pull pull the wire back a little and try again.
Happy "fishin'"
A little tip to those who are thinking about it. I read a few post about the trouble some have had getting the throttle wires thru the bars. Take a piece of fishing line and tie a small nut to it. Drop it thru your bars and remove the nut. Tie and tape it to the wires. This will help pull the wires thru as you also push them. It should take very litt effort to pull the wires thru. If it gets hard to pull pull the wire back a little and try again.
Happy "fishin'"