I did a search but couldn't find a situation as unique as this. When I hit the left blinker switch the left rear signal comes on and stays on while the front stay lit as a marker light (does not get brighter). However, if I hit both switches (hazard mode) both rears blink and the front right blink, but the front left stays in marker light mode.
Yes, I've tried switching the bulbs and I did wiggle the wiring with no help at all. So basically, the front left never flashes and the rear left only flashes when I hit the hazards.
I'm about one step from tearing out the wiring and checking it, but I wanted to check with the electrical pros first. I'm thinking that I may be missing something since the rear starts blinking in hazard. I have changed handlebars and did re-wire the switches, so there is always the possibility that something has gone wrong at one of the solder points, but I don't want to go there unless absolutely necessary. Any ideas?
BTW, I did run a ground wire from the blk wire terminal on the side of the bulb housing to the frame with no success. However, there are 2 other wires, I think they were purple and green. It's 2000 FXDWG, if that helps.
Thanks.
Yes, I've tried switching the bulbs and I did wiggle the wiring with no help at all. So basically, the front left never flashes and the rear left only flashes when I hit the hazards.
I'm about one step from tearing out the wiring and checking it, but I wanted to check with the electrical pros first. I'm thinking that I may be missing something since the rear starts blinking in hazard. I have changed handlebars and did re-wire the switches, so there is always the possibility that something has gone wrong at one of the solder points, but I don't want to go there unless absolutely necessary. Any ideas?
BTW, I did run a ground wire from the blk wire terminal on the side of the bulb housing to the frame with no success. However, there are 2 other wires, I think they were purple and green. It's 2000 FXDWG, if that helps.
Thanks.