J
Jack Klarich
Guest
You can use an impact wrench for the removal of the nuts on the compensator and the clutch. Do not use it for reinstalling the nuts.
I would not use a torch, to many bad things can happen.
Also if your '91 is the same as my '92 flhtc was you will need a special tool to remove the clutch pressure plate, don't try to pry the snap ring out without the tool the plate will break, I know from experience. As previous replies have stated, get a service manual before you start, its a good investment.
You sure you want to chance wrecking the magnets with an air wrench? HMMMMM, not me :s