allan19560
Account Removed
I sure hope someone can help me out on this?. I've got a 91 Glide, EVO 1340 ( 80CI ) and after removing the engine to do a top end and rering it I put new motor mounts, stablizers, did the vehicle alignment, and Timing, I still have a " Good Vibration " through the floor boards at aroung 2500 RPMS. No matter what I do I can't seem to get rid of this. Funny thing is before I did all of this the Vibration was never there. Well at least not on the floor boards. Could this be from the new rings and the new motor mounts??. The only thing I haven't replaced is the rear swing arm soft mounts. I don't think I left anything else out!!. I had bikes all of my life and never had one that kicked my(EDIT) this hard???. I'm completly open to anyones suggestion as well as anyones experience in this area???. Motor runs sweet with the exception of the Vibration. I followed the manual to a "TEE" with the installing of the engine, so I'm almost certain that the motor and primary are not the cause. It's not in the primary chain either. It's like when you excelerate the engine the vibration is felt through out the entire bike, fairing, baggs, ect, ect. I never messed with the bottom end either. I just can't think of anything else. I covered everything that I know of!!! I'm lost???. Any help from this fourm would be most greatly appreciated. Thanks Again in advance!!!. Allan
[notes]
A Friendly Reminder - Harley Davidson Community
[/notes]
[notes]
A Friendly Reminder - Harley Davidson Community
[/notes]
Last edited by a moderator: