I'm getting ready to do a 92-93 1340 EVO Base Gasket. I have a 1999 HD Shop Manual. Any and all help would be greatly appreciated. I do have very good shop skills and knowledge.
Thank you in advance.
Go Navy Beat Army
Is your '99 shop manual for Softails? Other '99's were twin cams, and have differences in reassembly procedures.
For a leak free job I would replace all the gaskets in the kit, follow the instructions supplied. Make sure ALL surfaces are clean and dry of all materials. As far as the mounts, any thing to get access to the rear bolts will be a big plus IMO The wrist pin C clips, I would replace ALL of them and make sure they are seated. I have pulled cylinders off with out removing pistons, you have to be careful the pistons do not hit the cylinder studs