Mike.Salvatore
Member
So I finally decided to put highway pags on my engine guard on my 2011 Electra glide ultra limited and am running into a problem.
I measured twice centered and adjusted pegs but I seem to be reaching farther on the right than on the left. I then noticed the engine guard on left has a slight bend towards the back of the bike yet the right guard is straighter.
I have never dropped the bike and the guards came stock from the factory.
Question: Is this normal for the dresser bikes or do you think it was it dropped at the dealer before I bought it new.
The pegs are evenly spaced and centered on the bar but my left leg is bent and my right I have to stretch for the peg. The bike was level on a lift when I installed them tonight. (EDIT) any one have any thoughts.
I measured twice centered and adjusted pegs but I seem to be reaching farther on the right than on the left. I then noticed the engine guard on left has a slight bend towards the back of the bike yet the right guard is straighter.
I have never dropped the bike and the guards came stock from the factory.
Question: Is this normal for the dresser bikes or do you think it was it dropped at the dealer before I bought it new.
The pegs are evenly spaced and centered on the bar but my left leg is bent and my right I have to stretch for the peg. The bike was level on a lift when I installed them tonight. (EDIT) any one have any thoughts.
Last edited by a moderator: