DIEHARD
Member
Hello: Looking to change out my 70 tooth rear pulley to a 65 tooth rear pulley for more top end and less rpm around 60 to 70 mph I heard its been done on some models but not sure if it can be done on mine. My belt is 1-1/8" it has 133 teeth My front has 32 t and my stock rear pulley is 70t. I would like to know if I go to a 65t 1-1/8" rear pulley and use everything else stock will my 133t belt be to long and run out of adjustment .I can get the 65t rear pulley in chrome for 129.00 and have access to a lathe to machine spacer if needed , what I do not want to do is have to replace the belt as this cost as much as the rear pulley and all the labor removing the primary cover , primary chain clutch etc. Has anybody done this on a 2003 low rider.