So I just went through a powder coat process for my dyna. The bike sat for a few months while waiting for everything to be complete and finally reassembled everything. In the process I put all new plugs and filters needed to reassemble the tank. Also, I cleaned the tank very well and flushed fuel throughout before reattaching lines.
I went for the first start up and fuel pump kicked on everything electrical seemed fine, and it started....for about 10 sec and then started starving for fuel and cutting out, however it would then idle back up and run clean for a few seconds before cutting out again, never stalling completely.
Now for the problem I have now. Filled the tank the rest of the way up (only had 1/2 a gallon to start) now I can't keep it running longer than a few seconds.
I know I'm leaving out a few key points, but any help would be appreciated.
I went for the first start up and fuel pump kicked on everything electrical seemed fine, and it started....for about 10 sec and then started starving for fuel and cutting out, however it would then idle back up and run clean for a few seconds before cutting out again, never stalling completely.
Now for the problem I have now. Filled the tank the rest of the way up (only had 1/2 a gallon to start) now I can't keep it running longer than a few seconds.
I know I'm leaving out a few key points, but any help would be appreciated.