TFI Question for those who have installed

Discussion in 'Touring Models' started by RetNavyHD, Mar 19, 2009.

  1. RetNavyHD

    RetNavyHD Member

    61
    18
    1
    I have all ready to go seat off tank lifted etc... and i'm looking at this and wondering what is the best way to run the wires to the injectors? Looking for help from those in the know to give me advice.

    Thanks in advance

    Ron
     
  2. amckay63

    amckay63 Member

    90
    16
    0
    Ron,

    I used a coat hanger and a set of helping hands to run them right next to the wire tray on my RG. We took a long time to see if the tank was going to rub against them, but they didn't and so far they appear to be fine.

    Adam
    ATC(AW/SW)
    USN(ret):small3d026:
     
  3. Bud White

    Bud White Well-Known Member Retired Moderators

    3,270
    48
    2
    i took the tank off and ran them right next to the main harness on backbone
     
  4. glider

    glider Veteran Member

    25,464
    108
    44
    I lifted the tank a bit and opened up the wire loom under the tank and laid them in there. Very easy to do and it protects the wires. It's just a plastic housing that snaps closed.
     
  5. STEVE07

    STEVE07 Well-Known Member Staff Member Super Moderators

    4,034
    68
    43
    I ran mine through the frame looms with the cruise control cable
     
  6. Bud White

    Bud White Well-Known Member Retired Moderators

    3,270
    48
    2

    whats a cable?dont forget 08 + are flyby wire on the dressers
     
  7. RetNavyHD

    RetNavyHD Member

    61
    18
    1
    Thanks to all for your responses!! I beleive I got it, just have to finish up the screamin eagle A/C and I can get to playing with it.

    Adam,

    West coast sailor your whole career? All east coast here did just over 20 years 15 1/2 on ships was good when i was single.

    Take care,

    Ron
    HTC(SW)
    USN(ret)
    1984-2005
     
  8. JPHarley

    JPHarley Active Member

    122
    28
    1
    Ditto....just ran the cables along the frame with the other ones.
     
  9. Retrop

    Retrop Active Member

    303
    28
    3
    Nobody else has mentioned this yet, but install the Screaming Chicken air cleaner before you put the tank back on. Removing the old air cleaner with the tank removed goes a whole lot smoother.
     
  10. amckay63

    amckay63 Member

    90
    16
    0
    Ron,

    I did a year in VA when the Nimitz went in the yards for refueling the reactor, but other than that it was all West coast (the first 10 in P-3's, which was sailor heaven! :small3d026: )