Radio

Discussion in 'Communications And Radio' started by ManinBlack, Nov 1, 2013.

  1. ManinBlack

    ManinBlack New Member

    1
    0
    0
    I installed the hogtune 6 speaker set with tweeter bar. Have everything mounted and located the equalizer where recommended by hogtunes. Installed a diode on the wire to the cig lighter also. Problem I have is I hear motor spark noise thru the speakers what can I do to eliminate this? Should I remove the diode?
     
  2. Dandekar

    Dandekar Member

    19
    0
    0
    Diode wont matter.
    Radio is picking up EMF from amp.
    Not uncommon.
     
  3. xcavater

    xcavater Member

    82
    0
    1
    Check ground connections including the antenna. Are you running aftermarket plugs or wires?
     
  4. kdaddy

    kdaddy Active Member

    179
    38
    8
    You need to talk to some industrial electronics folks about a 12volt efi filter. I use to put filters on new machines going to Europe to meet ce requirements. It was safety precautions for controllers in the cabinets.
     
  5. kdaddy

    kdaddy Active Member

    179
    38
    8
    Sorry meant to say emf filter.