I'm baffled!
I put the bike up on the jack to do some cleaning. While it was on the jack I started it and put it in 1st gear just to spin the rear wheel. Let it spin for about 30 seconds and then shut it down. I took it off the jack and went to start and had a hard time getting to start. Found the p1511 code and cleared it. I went out for a ride and everything seemed fine. About 5 miles out it went into limp mope. Pulled over and the code was back. Cleared and everything was fine but it keeps happening
Any umput would be appreciated
I put the bike up on the jack to do some cleaning. While it was on the jack I started it and put it in 1st gear just to spin the rear wheel. Let it spin for about 30 seconds and then shut it down. I took it off the jack and went to start and had a hard time getting to start. Found the p1511 code and cleared it. I went out for a ride and everything seemed fine. About 5 miles out it went into limp mope. Pulled over and the code was back. Cleared and everything was fine but it keeps happening
Any umput would be appreciated