I have the after market ignition switch with the five posts on it. I located the three active, acces, bat, start ( this is a spring loaded 0ff/On/Start )
I connect the coil to Acces, right? as the Crane ign module should light when the key is turned on ( if I hook it to bat, it just stays on all the time ) Connect Bat to Bat, ( and the altenator to Bat ) and the starter relay ( the little male/female plug ) to start.
The starter Pos goes to Bat Pos, and the starter Neg is grounded from the starter mounting bolt to the Bat Neg. I have not hooked up any lights.
I turn the key on, the ign module is lit...turn to start, I get one loud ckick...thats all. Hit start again, nothing. The battery has full charge, I just had the starter and solenoid checked, both good.
Any ideas? No wires are grounding out, right now everything is out in the open. Sure would like to get her going, before summer is over, without spending lots of cash to have someone else do it.
Thanks.
I connect the coil to Acces, right? as the Crane ign module should light when the key is turned on ( if I hook it to bat, it just stays on all the time ) Connect Bat to Bat, ( and the altenator to Bat ) and the starter relay ( the little male/female plug ) to start.
The starter Pos goes to Bat Pos, and the starter Neg is grounded from the starter mounting bolt to the Bat Neg. I have not hooked up any lights.
I turn the key on, the ign module is lit...turn to start, I get one loud ckick...thats all. Hit start again, nothing. The battery has full charge, I just had the starter and solenoid checked, both good.
Any ideas? No wires are grounding out, right now everything is out in the open. Sure would like to get her going, before summer is over, without spending lots of cash to have someone else do it.
Thanks.