I have 1994 Wideglide 1340 EVO with split tank and I want to remove the fuel sender to install a new gasket as fuel is weeping from joint when tank is full and bike is leaned over on sidestand.
I can remove the gauge and wiring no problem. Then I remove the TORX screws holding the sender in place but I cannot seem to be able to manouver the sender itself out of the opening in the tank.
Is there some special way to do this?
Any help would be appreciated
Thanks
Tom
I can remove the gauge and wiring no problem. Then I remove the TORX screws holding the sender in place but I cannot seem to be able to manouver the sender itself out of the opening in the tank.
Is there some special way to do this?
Any help would be appreciated
Thanks
Tom