exhaust cones ?

Discussion in 'Engine, Fuel and Exhaust' started by marknett, Jun 2, 2011.

  1. marknett

    marknett Active Member

    205
    0
    1
  2. Redfish-Joe

    Redfish-Joe Senior Member

    2,307
    48
    10
  3. BUBBIE

    BUBBIE Well-Known Member

    4,959
    83
    113
    I have used them on one of my TC builds with low back pressure set up.. AS a reversion the cones worked great..

    But just don't use them to use them... WITH Lower back-pressure or shortened straight pipes they help

    signed....BUBBIE
     
  4. TQuentin1

    TQuentin1 Well-Known Member Staff Member Moderator

    4,633
    83
    100
    I have cones in my Dyna (EVO) that has drags on it.

    TQ
     
  5. BUBBIE

    BUBBIE Well-Known Member

    4,959
    83
    113
    Were you getting Popping in the exhaust Before you installed them?

    mine quit Most of the pop bang boom after i installed my cones..

    signed....BUBBIE
     
  6. TQuentin1

    TQuentin1 Well-Known Member Staff Member Moderator

    4,633
    83
    100
    I never did run the drags without the cones. When I redid the bike in '99, I installed the drags and included cones at that time. Before that I ran the OEM headers and slip-ons.

    TQ
     
  7. marknett

    marknett Active Member

    205
    0
    1
    Im running v & h straight shots that end behind passenger . no baffles . would cones help give me a little torque
     
  8. Jack Klarich

    Jack Klarich Expert Member

    18,544
    153
    399
    It sure aint going to hurt, and easy to install:s
     
  9. BUBBIE

    BUBBIE Well-Known Member

    4,959
    83
    113
    I put the revision cones because i had the end baffles out of the mufflers.. SO it should help your bike gain some back pressure along with the revision of the gasses,, Mainly I was after the POP pop pop that went away....

    signed....BUBBIE