Bolt in cams

Discussion in 'Engine, Fuel and Exhaust' started by jdaws, Feb 22, 2010.

  1. jdaws

    jdaws Active Member

    I am thinking about installing a set of bolt in cams. I want a little more power and keep it under $500. I have V/H big shots, High Five air cleaner and a gen III TFI. Cams, push-rods and a clutch spring is what I am thinking. I have been looking at the S&S 583 easy start cams. Has anybody else tryed them? What other cams should I consider? :)
  2. Chopper

    Chopper Senior Member

    Have never ran S&S 583 but there's alot of cams out there to consider.
    My favorite for dyna's are S/E 211's

    Here's a S/E 255 cam dyno graft:

    Here's a woods TW6-6 cam , might be a good on for a lighter bike like the Dyna, takes off with about 10 ft lbs less torque then 255 but have more ponys up high.