Before & After 2011 SE ultra Stage 1

Discussion in 'Dyno Runs' started by Brutal FXDX, Dec 3, 2010.

  1. Brutal FXDX

    Brutal FXDX Active Member

    155
    28
    2
    Just put a brand new 2011 FLHTCUSE6 on the dyno for some before and after comparison runs. This first chart is bone stock out of the box with 10 miles. right now im installing V&H power duals with rinehart slipons. Back in the dyno in a few hours for a full tune with SEST and i will repost the numbers. Its possible to get it done tonight but most likely tomorrow morn.


    [​IMG]
     
  2. Brutal FXDX

    Brutal FXDX Active Member

    155
    28
    2
    Guess it will be tomorrow to post the after results. They just brought me a trailer hitch to install as well:bigsmiley19:

    JD
     
  3. Slope

    Slope Member

    13
    11
    0
    Cool! Waiting to see the results. Thanks.

    Sent from my DROID2 using Tapatalk
     
  4. Brutal FXDX

    Brutal FXDX Active Member

    155
    28
    2
    Here are the after runs so far. it still needs some fine tuning. If you are using SEST on any touring bike 2010 or later the VE tables are no longer in throttle position and RPM. It is now Map load (KPA) and RPM, so the tuning method is totaly different than pervious.

    [​IMG]
     
  5. NEWHD74FAN

    NEWHD74FAN Experienced Member Retired Moderators

    8,176
    98
    16
    Very good numbers, and A/F mixture much closer to nominal 12.5 for cooler running...