Another Handlebar Question

Discussion in 'Touring Models' started by hotrodjohn, Dec 23, 2011.

  1. hotrodjohn

    hotrodjohn Active Member

    183
    0
    0
    I installed the Harley Pullback bars on my 11 ultra and I am not wild about them. They really come back a little to far and the angle of my wrists are different than the stock bars. I am considering making my own. I would like the stock wrist angle but I want the controls about an inch or so closer. The pullbacks say they are two inches closer. To much. Any suggestions??
     
  2. HDDon

    HDDon Experienced Member Contributor Retired Moderators

    5,456
    133
    196
    If these are the stainless bars you should be able to use a pipe bender and move the top portion of the bars back toward the front of the bike about an inch. Trying this on the chromed type could crack the chrome.