2006 XL883C Horn & Turn Signals Not Working

[DeathHellGrave]

Hi Everyone!

This is my first post on here, so first off greetings from across the pond!

I'm an extreme newbie to Harleys, & Bikes in general.

Recently i removed the turn signals from my 2006 XL883C, and the handlebar switches stopped working all except the Hi/Low, Run, & start.

After i realized that they would not work without turn signals plugged in i put them back on, but still nothing! The turn signals are the originals & there is power going to them as when i set the alarm they flash.

Thanks in advanced for any help!

 

[gator508]

Welcome aboard!

This maybe obvious, but, if they worked prior to you removing them, then you messed up something in the wiring and or fuses.
I would check the wiring for chaffing or cuts etc., and check the fuses for any that are blown. Good luck!

 

[tourbox]

Welcome from So. Texas. As Gator508 stated, that's where I would start. Make sure the wire loom is in the dimple of the handle bar near the switches.
tourbox

 

[dbmg]

Get a shop manual.