2006 FXDi35 Rotor and Stator

Discussion in 'Dyna Models' started by stevec217, Aug 18, 2011.

  1. stevec217

    stevec217 New Member

    2
    0
    0
    Hello everyone, I'm new to the forum. Just want to start by saying thank you to everyone for all of your tips and tricks and for providing a great place to find info about my bike and it's issues.

    Yesterday I replaced the stock 2 piece rotor (completely shredded the stator) with the one piece upgrade as well as the stator. I installed everything just the way it came out and the bike runs great. When I put the bike in gear, the clutch was grabbing. I adjusted the cable and clutch pack as specified in my service manual but it's still grabbing, and it slips during acceleration. Could my clutches have been damaged by the rotor explosion? I'm not a clutch expert by any means, I would like to get some insight before I buy a new clutch pack.

    Thanks everyone!
     
  2. Jack Klarich

    Jack Klarich Expert Member

    18,544
    153
    399
    Harley Davidson Community try this on a cold bike:s
     
  3. JBC2565

    JBC2565 Junior Member

    582
    28
    2
  4. stevec217

    stevec217 New Member

    2
    0
    0
    I'm running HD Primary fluid, however, all of the leftover (EDIT) has contaminated the fluid. I'll change it again tomorrow and pull everything apart to make sure I didnt install something incorrectly.


    Please read this...
    [note]
    A Friendly Reminder - Harley Davidson Community
    [/note]
     
    Last edited by a moderator: Aug 19, 2011
  5. JBC2565

    JBC2565 Junior Member

    582
    28
    2
    What is that? Formula +?? Never had an issue with formula +. Good lube for primary. Recently went with spectro primary because was at indy dealer who sold spectro tranny fluid. One stop shop.
    Also, if you fried your stator, primary fluid would be real black and smell burnt. Needs to be changed.
     
  6. sgmfisher

    sgmfisher Member

    44
    0
    0
    Some times you have to tear the clutch pack compleatly down and clean each and every piece. Look for warped disks or plates. In the wind.

    Pops

    What brand rotor and stator did you put in??

    Pops
     
    Last edited by a moderator: Aug 19, 2011