Evening all - I'd appreciate some much needed guidance with diagnosing a 'no spark' issue I'm having with my bike. The engine cranks, fuel is present but no spark to either plug. Up to this point the bike had been progressively getting worse with the daily initial startup...10-15 seconds of cranking before it kicked over.
Here are the tests and results so far:
1) battery kicking out 13.16 V
2) 11.73 V making it to Terminal-B of the coil connector
3) resistence of front & rear plug wires (6.62K & 2.99K resp.) within factory spec (front: 4.75K-11.23K & rear: 1.812K-4.375K)
4) resistence of coil primary circuit is 1 ohm (factory: .5-.7)
5) resistence of coil 2ndry circuit is 5.86K (factory: 5.5K-7.5K)
6) test lamp on Terminal-A and -B of coil connector, with engine cranking gives NO light
I'm thinking that my next step would be investigating the crank position sensor but I do not have the tool (i.e., breakout box) to properly diagnose.
Am I missing something in my troubleshooting methods?
Thank you.
Here are the tests and results so far:
1) battery kicking out 13.16 V
2) 11.73 V making it to Terminal-B of the coil connector
3) resistence of front & rear plug wires (6.62K & 2.99K resp.) within factory spec (front: 4.75K-11.23K & rear: 1.812K-4.375K)
4) resistence of coil primary circuit is 1 ohm (factory: .5-.7)
5) resistence of coil 2ndry circuit is 5.86K (factory: 5.5K-7.5K)
6) test lamp on Terminal-A and -B of coil connector, with engine cranking gives NO light
I'm thinking that my next step would be investigating the crank position sensor but I do not have the tool (i.e., breakout box) to properly diagnose.
Am I missing something in my troubleshooting methods?
Thank you.