2.5 inch baffles on 96cubic EFI 2007. Help

Discussion in 'Engine, Fuel and Exhaust' started by FATSWEDE, Jun 17, 2009.

  1. FATSWEDE

    FATSWEDE New Member

    4
    11
    0
    I have a race fueler SE and slip on RUSH mufflers with 2,5 inch baffles I also have a stage one SE air cleaner, Does anybody have an opinion on whether it is wise to put these components on my 2007 EFI bike 96cubic inch, or whether it is possible, I heard somewhere that 2,5 inch baffles are not compatible with EFI engines.
    Oh YEAH and HI EVERYONE
     
  2. Grillfish

    Grillfish Junior Member

    652
    28
    2
    I have V&H slipons w/ TFI and Ness big sucker. The mufflers have 2 1/4" baffles. I did loose some low end. It did run fine however. But I got Big City Thunder QQ monster baffle that goes into the headpipe. I put only one in on the left side before the muffler. Now it's awesome. Sounds great, creates asymetrical exhaust system, like fuelmoto. But again it's a touring exhaust, different than a FB.

    You can change out the Rush baffles though to something smaller.
     
    Last edited: Jun 18, 2009
  3. FATSWEDE

    FATSWEDE New Member

    4
    11
    0
    Thanks for your answer. I had them installed yesterday great sound! love it, bike runs fine.
     
  4. sharpscuba

    sharpscuba Banned

    945
    0
    1
    I have the rush slipons TFI, and ness big sucker on my 07 tour classic. Had a bit of a problem with the mode 4 setting but Matt from Dobeck got it right. Love the added power. I will see about the gas milage this weekend as there is a state rally and then the wife and I are going to the north woods.