Wiring Newbe, again

Discussion in 'Electrical' started by neverdown, Jul 21, 2008.

  1. neverdown

    neverdown Member

    22
    11
    0
    I ran a jumper wire from the positive post to the relay on top of the solenoid ( assuming this should crank the starter )..... nothing. Bads starter? Is it possible I burned something out when I tried to start it, if the wiring was not right?
    Thanks
     
  2. glider

    glider Veteran Member

    25,464
    108
    43
    You have to run that jumper to the small terminal with the green wire that is on the solenoid. If a no start or crank occurs, it could be the solenoid or the starter. You can jump the solenoid directly to the starter input to verify the starter itself.