turn signals

Discussion in 'Dyna Models' started by superglyde, Jun 12, 2011.

  1. superglyde

    superglyde Member

    15
    11
    0
    I removed my front signals. now my rear left works and right does not.any body got a fix for this
     
  2. Hoople

    Hoople Account Removed

    7,198
    0
    34
    My guess would be the system needs some load resistors to balance out the circuit. The TSM needs to think the front bulbs are still installed.
     
  3. glider

    glider Veteran Member

    25,464
    108
    44
    I agree with Hoop. The TSM/TSSM is designed to work with a certain load and if you change the load, it will not operate properly.
     
  4. R_W_B

    R_W_B Senior Member

    2,425
    0
    23
    One way to tell for sure is just pop the wires out the bottom and hook the front sigs up temp real quick. If everything works then Hoop and Glider nailed it and you need to either keep your front sigs or hunt down a load equalizer.

    By the way guys where does one buy these things. Do they generate heat the way the run/turn modules do ?

    I've read that you should not leave your flashers on too long with a run/turn module installed since they can overheat and fail.
     
  5. sprinklerfitter669

    sprinklerfitter669 Junior Member

    982
    0
    6
    How about a loose wire when you put them back on ?
     
  6. R_W_B

    R_W_B Senior Member

    2,425
    0
    23
    A loose wire is always possible but if I read his post correctly he did not remove his rear ones only the front. The rear ones connect under the seat, the front ones connect under the frame neck.