free website stats program Turn signal | Harley Davidson Forums

Turn signal

Jays3hds

New Member
My left rear turn signal stays on very dim, with ignition off.

I have LED signals and tail lights on my 2010 Road King Classic.

I checked all fuses, they are ok. I pulled the fuses and checked them with an ohm meter.

If I turn the ignition switch to acc.and back off, the light does go out.

They function as they should otherwise.

These are Harley LED (plug and play)Lights.

I have no alarm system on the bike.

Any ideas?


Thanks
Jay
 
Might have a short somewhere thats causing it to keep pumping power or whatever controls the electronics on your bike when you turn it on could be bad. Sorry not real clear.


Sent via telegraph
 
My left rear turn signal stays on very dim, with ignition off.

I have LED signals and tail lights on my 2010 Road King Classic.

I checked all fuses, they are ok. I pulled the fuses and checked them with an ohm meter.

If I turn the ignition switch to acc.and back off, the light does go out.

They function as they should otherwise.

These are Harley LED (plug and play)Lights.

I have no alarm system on the bike.

Any ideas?


Thanks
Jay

Do you have factory warranty left? 2 years unlimited miles
 
Instead of turning the ign off and on, remove the seat and try leaving ign off while the fault is occurring and wiggling the wiring a little bit. Also check under the fender where it goes into the taillight housing for bad insulation or corroded connector prongs.

I'd go ahead and clean and dielectric all the connectors while I was in there if they don't look good enough already.
 
Back
Top