Transmission

Discussion in 'Transmission' started by jacobdavis, Jun 16, 2012.

  1. jacobdavis

    jacobdavis New Member

    1
    0
    0
    I am trying to remove the belt pulley from the transmission shaft I have a long 1 7/8 socket but I am not sure which way to turn it can anyone help please? I have tried both ways but so far no luck.
     
  2. lordharold

    lordharold Active Member

    191
    0
    2
    yes, the nut is left hand thread.so to remove it turn it clockwise
     
  3. fin_676

    fin_676 Experienced Member Staff Member Moderator Contributor

    5,278
    133
    156
    The nut is on fairly tight and held in place by loctite 262 so you will need to use a fair bit of heat to break the loctite bond
    And as has been stated a left hand thread

    Brian