Swingarm bearing retrofit

Discussion in 'Touring Models' started by oldav8r, Feb 23, 2010.

  1. oldav8r

    oldav8r Member

    5
    11
    0
    Has anyone here reverse engineered a Custom Cycle Engineering spherical bearing swingarm retrofit setup for a Road King? I ride a 2001 FLHRCI and want to machine my own. I'm a machinist and the ads I've seen look like basic turning work. If someone has done this, would you share dimensions, diameters etc. and what was your source for the spherical bearings? Did the shaft require heat treating?

    Thank you in advance!

    Regards and blessings,
    Mike