slip ons

Discussion in 'Dyna Models' started by rmouse2, May 18, 2010.

  1. rmouse2

    rmouse2 Member

    10
    0
    0
    hello everybody, i have an 08 super glide custom and would like a little more noise out of my pipes, so my qustion is will slip on s give me more noise and will i have to have the shop do some tuning such as air/fuel mix and be put on the dyno??? any input will be greatly appreciated...
     
  2. glider

    glider Veteran Member

    25,464
    108
    44
  3. rmouse2

    rmouse2 Member

    10
    0
    0
    THANKS Glider.. im not much of a mechanic.. is this a project for me or the shop??
     
  4. glider

    glider Veteran Member

    25,464
    108
    44
    It's not difficult, you should be able to do it.
     
  5. maine-e-axe

    maine-e-axe Junior Member

    732
    28
    1
    It's gravy, 9/16 on the clamps (2) and 4 1/2 nuts on the bracket/hanger and you get to bond with your bike. Its a good time to clean the rear wheel while the pipes are off.:s
     
  6. rmouse2

    rmouse2 Member

    10
    0
    0
    thanks everybody... i wasnt worried bout putting the pipes on but wasnt sure what the tuner required i mean i can wire it but as far as it being lean or rich im lost....
     
  7. hogtyd

    hogtyd Member

    72
    16
    0
    If you are considering a set of rush slipon's I have a nice set with 1 3/4 baffles and nice end caps I would like to sell for $150.00 PM me.
     
  8. Jack Klarich

    Jack Klarich Expert Member

    18,544
    153
    399
    Rush is a good choice alot of H D dealers are selling them over screaming eagle go figure:s