Sissy Bar Medallion

Discussion in 'General Harley Davidson Topic' started by Badgerw, Jul 19, 2010.

  1. Badgerw

    Badgerw Member

    58
    16
    0
    I have a 2010 Heritage Softail Classic. The bike came with a piece of tan/brown leather with a Concho attached to it which in turn is attached to the back of the sissy bar. I thought the leather Concho looked tacky so with great difficulty removed it from the sissy bar. I was looking at sometype of a Harley Davidson Self-Adhesive Madallion to replace it with. Once I removed the leather I discovered 3 holes that held the piece of leather and a center screw connecting the sissy bar to the back seat rest. The screw is a round headed screw, and the hole is not countersunk. Any suggestions on what type of Medallion would fit. My theme for the bike is the Harley Davidson Motor Company Logo. Has anyone else run into the same issue? I am open for any suggestions.
     
  2. Davidw2415

    Davidw2415 Senior Member

    1,456
    46
    0
  3. Keithhu

    Keithhu Active Member

    133
    16
    0
  4. xlcruser

    xlcruser Active Member

    179
    26
    0
    [​IMG]

    This is what I used.
     
  5. Dr.Evil

    Dr.Evil Junior Member

    694
    0
    5
    My 05 came with a factory dommed chrome cover that press fits over the phillips head screw. It has a pin that sticks out that indexes with a drilled hole to keep it from rotating. If you wish I can grab a pic and post it.
     
  6. Dr.Evil

    Dr.Evil Junior Member

    694
    0
    5
    Correct my own post. I havn't had it off in a while. The cover has two plastic pins on each side of the screw that push into holes that have retainers in them. I also noticed the chrome flaking off mine