Sissy bar hardware

Discussion in 'Sportster Models' started by jnoonan1, Jun 12, 2009.

  1. jnoonan1

    jnoonan1 Member

    9
    11
    0
    I was wondering if there is a standard size torx screw for attaching a Harley sissy bar to the mounting plates.It seems to be smaller than a T30 but I dont have any other sizes to check with.Thanks
     
  2. robNY

    robNY Member

    7
    11
    0
    i will have a look first thing in the morning, and will post a response.

    i have the detachable hardware kit on my nightster.

    i did the docking hardware - T40 and a 1/2 closed end wrench to remove oem, and a 3/16 male bit to install.

    side plates, sissy bar and pad - T25, T27 and 3/16 male bit.

    get the T27 don't screw around with a T25 in a 27 slot... you will strip everything!!
     
    Last edited by a moderator: Jun 16, 2009
  3. jnoonan1

    jnoonan1 Member

    9
    11
    0
    Thanks for the info.It was T27.
     
  4. robNY

    robNY Member

    7
    11
    0
    a swivel head on the ratchet helped get around the turn signals on the nightster when installing the docking hardware.

    the two up rallyrunner, and sissy bar - rack combo ruin the lines of my nightster, but it is a quick 2 minute change out to the solo seat. adds function, and allows for a few more options.