SERT map or Timming advice

Discussion in 'Engine, Fuel and Exhaust' started by hogrotten, Nov 7, 2011.

  1. hogrotten

    hogrotten Junior Member

    636
    28
    2
    Looking for a map for an 08 96" with 203 cams ,pipes and a/c.
    I have the cals. for the SERT but the stge 2 maps are for the big bore kit with the 255 cams. I know I"ll need to adjust the timming when I install the cams but could use some constructive advice on where to start.

    Thanx for your help fellas.
     
  2. Hoople

    Hoople Account Removed

    7,198
    0
    34
    Do you mean Timing as in spark advance? As far as the big bore cubic inches go, you can always load the big bore stage 2 map into the software, then dial back the displacement to "96" using the engine displacement tab under "Tuning Setup". That should offset the VE tables perfectly.

    Don't know what to tell you about the VE offset needed to go from 255 vs 203.
     
  3. hogrotten

    hogrotten Junior Member

    636
    28
    2
    Do you think the timing for the 255 and 203 would be close?