Quiet baffles V&H

Discussion in 'Engine, Fuel and Exhaust' started by FXDC_Stu, Jun 23, 2009.

  1. FXDC_Stu

    FXDC_Stu Member

    12
    11
    0
    I've just bought a set of V&H quiet baffles for a set of staggered short shots. They came with no instructions.

    Can somebody tell me if I need to remove the whole system in order to remove the current baffle and fit the quiet ones?

    Thanks
     
  2. martin14

    martin14 Active Member

    373
    26
    0
    well, I found a link to some else who did it, but now I'm not sure if I

    can put up a link to *coughcoughanotherwebsitecough*

    so I pmed you :)
     
  3. 00BUCKSHOT

    00BUCKSHOT Junior Member

    446
    26
    0
    i would think there is a cap head 1/4-20 bolt in the rear of the pipe on the left hand side remove that and then pull old baffle out