Problem with clutch cable

Discussion in 'Transmission' started by Snydcat, Jun 2, 2010.

  1. Snydcat

    Snydcat New Member

    3
    11
    0
    I'm installing 12in. z bars on my 07 street bob and i'm using the stock clutch cable but there seems to be a problem i can't figure out. Problem is that i have the adjustment unscrewed all the way out and there is still to much slack and it seems to be binding up.

    I took the tranny cover back off and the movement with ball bearing piece inside doesn't seem to be smooth and i can't figure out way. Anybody else ever had this problem? How did you fix it?
     
  2. NEWHD74FAN

    NEWHD74FAN Experienced Member Retired Moderators

    8,176
    98
    16
    Snydcat, welcome to the HDT forum. Did you compare the cables side by side and confirm the ends match up the same?, the only difference should have been the length of the sheath...the exposed ends should be identical in length.
     
  3. glider

    glider Veteran Member

    25,464
    108
    44
    Are you sure all 3 balls are still in the ramps?