Power Commander Fuel Map, Help!

Discussion in 'Softail Models' started by NYHarley, Jun 8, 2010.

  1. NYHarley

    NYHarley Active Member

    120
    26
    0
    Ok, so I have a Power Commander on my 2007 Night Train, and I have received two different suggestions from Dynojet regarding what Map to use. I am running a screamin eagle filter kit and Rinehart 2 into 2 Racing Exhaust w/ Baffles installed. I was told by Dynojet to use either of the maps below, but my concern is the fuel maps are quite different. I know this is a base mark, but I want to use something close until I can get some dyno time:

    Map - M813-039
    2007 Harley Davidson Softail *Advanced Map*
    Bub 2:2 7 system Exhaust
    Screamin' Eagle air filter
    Stock ECM
    Rev Xtend enabled
    Fuel table 1 is rear cylinder

    Map - M813-007
    2007 Harley Davidson Softail models
    Rinehart 2:2 full exhaust
    Screamin' Eagle Air filter
    Stock ECM
    Dynojet O2 sensor eliminators installed
    Rev Xtend enabled
     
  2. TripleJ

    TripleJ Senior Member

    1,081
    48
    8
    I agree with Hobbit on the Map - M813-007 but would add to try both and see how your bike responds to both. Doing so will not do any harm.

    I am running the Rinehart Crossbacks on my 08 Heritage and did not like the performance with any of the maps I tried for the Crossbacks and ending up using a map for the Vance and Hines True Duals and it made a huge difference in performance.

    Good luck!