Power commander dn loads for 95ci

Discussion in 'General Harley Davidson Topic' started by panheadbill23, Sep 11, 2010.

  1. panheadbill23

    panheadbill23 New Member

    2
    0
    0
    I just rebuilt a 2006 FXSTI to a 95ci hcp and 570 S&S gear drive cams. unable to find proper power comander III down load. what one is closest?
     
  2. 03hdfatboy

    03hdfatboy Member

    47
    16
    0
    Your better off getting someone to build you a custom map. Guess wrong and you could be too lean or too rich and may cause you problems.

    Just my 2 cents
     
  3. panheadbill23

    panheadbill23 New Member

    2
    0
    0
    just need something close to get 500 miles to do a dyno
     
  4. 03hdfatboy

    03hdfatboy Member

    47
    16
    0
    Oh, OK if that is all your trying to do just leave the stock map in it until then, It will be fine. That's what I did.
     
    Last edited: Sep 12, 2010
  5. dcfatboy

    dcfatboy Active Member

    153
    26
    0
    Contact dynojet.

    (I would think the stock map would be way too lean.)
     
  6. kmcnabb

    kmcnabb Member

    16
    0
    0
    I just did a very similar build in my 06 street bob and have a couple of maps I could send you if you want. I ran them for 1000 plus kilometers till I got to a dyno with no issues.

    Moderator's note: email removed to prevent spamming. Use this forum's PM system instead.
     
    Last edited by a moderator: Sep 13, 2010