Pciii

Discussion in 'Engine, Fuel and Exhaust' started by braddebs, Jun 8, 2009.

  1. braddebs

    braddebs Member

    47
    16
    0
    My fuel mileage has dropped, I emailed Jamie at Fuel Moto and he said to change the throttle position. Can we get some feed back on how to change this through the Power Commander software while hooked up to the module.
     
  2. braddebs

    braddebs Member

    47
    16
    0
    We have it off of the bike and hooked up USB powered by the 9 volt battery.
    Your saying all we need to do is open the throttle setting window from above in the drop down window. We are trying to get better fuel mileage what direction do we need to go, up or down. What do you recommend?
     
  3. relxn88

    relxn88 Member

    37
    16
    0
    When you say "Jamie says change the throttle position", he may mean zeroing out the "0" throttle while it's on the warmed up bike. With the PC111 on the warmed-up bike, you should see( with the control center program open on your computer) the throttle position @ "0" when the bike is at an idle. If not, you can reset the idle(using instructions) with Set Throttle position(just for closed < -NOT reset) in the Power Commander tools section.