Oil Cooler Hookup on 2010 SuperGlide 96TC

Discussion in 'Dyna Models' started by wilks3, Dec 24, 2009.

  1. wilks3

    wilks3 Junior Member

    623
    0
    1
    The pipe plugs in front of the oil filter mount are for a oil cooler, right?
    If so, do you have to do anything behind the oil filter? i.e. change or add a
    directional fitting? If not, how does oil go through filter/cooler and back to engine?
    I was looking at a Jag cooler. Good, bad?
    Do you need Jags adaptor for cooler to work or will factory oil holes work?
    Thanks In Advance!
    wilks3
     
  2. Bud White

    Bud White Well-Known Member Retired Moderators

    3,270
    48
    2
    no the pipe plug will bypass the filter .. you have a mount that goes inbetween the filter and block that feeds the cooler ..
     
  3. wilks3

    wilks3 Junior Member

    623
    0
    1
    Bud, Thanks! Was sitting here looking around web site and found same question I asked.
    Which oil cooler (your opinion) works best...bottom front or the side frame mount?
     
  4. Bud White

    Bud White Well-Known Member Retired Moderators

    3,270
    48
    2
    thats been debated and what ever ya like is best one both have advantages and disadvantages i went with the harley one which for a touring bike is a low mount
     
  5. 2006FXDCI

    2006FXDCI Active Member

    182
    28
    1
    I like Jaggs setup, it was easy to do and looks killer.
     

    Attached Files: