Need some advice......

Discussion in 'Engine, Fuel and Exhaust' started by NickS, Apr 17, 2009.

  1. NickS

    NickS Member

    79
    16
    0
    ok so my check engine light is coming on and off at different times. As per Glider I checked the code and the answer is rear O2 sensor failure. The thunderheader exhaust has o2 sensors but neither are hooked up. I assumed with the PCIII that they were eliminated. So i ordered a replacement 02 sensor eliminator plug. I can not for the life of me figure out where to plug it into it. Any help?
     
  2. STEVE07

    STEVE07 Well-Known Member Staff Member Super Moderators

    4,034
    68
    42
    Reach down in the hollow beside your oil dipstick and grab the small harness down there,just pull it up and you will see the connector.
     
  3. NickS

    NickS Member

    79
    16
    0
    thanks steve. I found the eliminator. But there is only 1. Is this the Rear Sensor? Is the front located somewhere else?
     
  4. NickS

    NickS Member

    79
    16
    0
    Got it. No more code. Thanks guys I appreciate the help. Got one more....Any way of telling if a bike as a SE II or III kit from looking at it from the outside?