Need advise on proper cam for 94 fxdwg

Discussion in 'Dyna Models' started by dafuzz89, Feb 3, 2011.

  1. dafuzz89

    dafuzz89 New Member

    1
    0
    0
    I have a 94 FXDWG that I have installed high comp heads and matching 10 over pistons. I have an S&S carb, Crane single fire ignition, andrew adjustable pushrods, jims lifters. When I started tinkering with this bike years ago I installed a Bartells BP 40 cam and know since I have done the above the bike does not seem to perform as well as it should. I was told I did it (EDIT) backward and should have bought the cam after knowing what I want to do with the rest of the after market parts.

    I am told the SE 57 is an all around good cam for my set up.

    Any advise would be greatly appreciated. :newsmile04:


    Please read this...
    [note]
    A Friendly Reminder - Harley Davidson Community
    [/note]
     
    Last edited by a moderator: Feb 3, 2011
  2. BUBBIE

    BUBBIE Well-Known Member

    4,959
    83
    113
    **************************

    If you can post the information about that cam so I don't have to go look it up.. Lift,Open Close of both valves and duration it would give me an Idea Where to start.. Also How much pressure on each piston/cylinder ? meaning Compression checked? front and back

    How many miles on the build and any other information so we can get a better picture..

    signed....BUBBIE
     
  3. Jack Klarich

    Jack Klarich Expert Member

    18,544
    153
    399
  4. karlsbike

    karlsbike Active Member

    264
    0
    3
    Also, what sort of lifts can those heads accommodate, .600+?
     
  5. Breeze3at

    Breeze3at Well-Known Member

    4,645
    83
    124
    What kind of "high comp" heads? I have seen stock heads that have been worked over by the local porting specialist that would not run right with any combination of carb. and cam.