Molex Crimping Tool???

Discussion in 'Electrical' started by 09GLDR, Apr 19, 2009.

  1. 09GLDR

    09GLDR Member

    83
    16
    0
    OK Guys, after many searches on the www. I still cannot figure out which crimping tool I need for the Molex Pins. I'm not a HD mechanic, but I run a small shop out of my garage on the side and have been real busy lately with ape hanger handlebars (did 3 last week and have 2 more coming in this week) I've done many of bars but last week I snapped a few pins and had to solder new ones on, what a headache! I know there is a crimping tool out there somewhere, but which one? Any pics and/or model numbers would be greatly appreciated. Thank you for any info.
     
  2. glider

    glider Veteran Member

    25,464
    108
    44
    Take a look in the back of the factory service manual,they have part numbers for the tools there for the specialty tools needed.
     
  3. 09GLDR

    09GLDR Member

    83
    16
    0
    Thanks glider, got a pic and a part #, why didn't I think of that! Thank again buddy!
     
  4. glider

    glider Veteran Member

    25,464
    108
    44
    There ya go now!

    Glad to help out.:D
     
  5. silentflyer

    silentflyer Active Member

    341
    26
    0
    Newark Electronics (newark.com) has them if you can live with out the factory part# and logo on the box. Less $$$ too.
     
  6. 09GLDR

    09GLDR Member

    83
    16
    0
    Right on Thanks flier!
     
  7. bfmitch

    bfmitch Active Member

    133
    26
    1