Looking for settings

Discussion in 'TFI Questions Answered By Dobeck' started by clap, Dec 29, 2011.

  1. clap

    clap Member

    22
    13
    1
    I have an 02 Electra Glide ,V & H true duels ,203 cams , Stock air box / K & N filter& S E slip-on's . I don't have any popping but to look at the pipes it seems like it is lean. When you wipe your finger in the end of the mufflers it is clean. I have the bike stored right now due to the weather and don't know what my settings are. Also seems like I had alot more heat comming off the rear cylinder than it usually did. Thanks Clap
     
  2. sanec1

    sanec1 Active Member

    159
    28
    1
    TFI has great service. I'm sure they will be responding to your question. You can also give them a call. Welcome to the site. Now that your bike is stored you will probably be sending some time here.
     
  3. Jack Klarich

    Jack Klarich Expert Member

    18,544
    153
    399
    Harley Davidson Community This is worth a look:s
     
  4. glider

    glider Veteran Member

    25,464
    108
    44
    If you don't have a tuner on that bike, you would see a noticeable difference using a TFI like Jack posted above. It will add more fuel to cool things off and it would run much better too.
     
  5. clap

    clap Member

    22
    13
    1
    But I do have a tuner on it . I have a TFI I just need the numbers to see if I have it set close to what it should be. Thanks
     
  6. glider

    glider Veteran Member

    25,464
    108
    44
    You didn't mention that you had a tuner in your first post other than "looking for settings" in the title that I see now.

    You can find the settings here as well as on the Dobeck site.

    Harley Davidson Community

    Always look in the self help for answers, you'll usually find what you need there.
     
  7. DobeckTechSupport

    DobeckTechSupport Active Member Product Contributor

    149
    28
    2
    clap - Sorry for the delayed response, but we take a long holiday break.

    Recommended TFI settings to start at for your setup would be:
    GRN @ 1:30
    YEL @ 4:00
    RED @ 4:00
    RPM @ 4:00

    If the idle still seems too rich then go ahead and turn the RPM pot to 7:00. This will revert the idle fuel back to stock levels, engage the GRN fuel right above idle, and automatically set the GRN to RED cross over at 4000 rpm.
     
  8. clap

    clap Member

    22
    13
    1
    Thank you I will set it at that and see what it does
    Clap
     
  9. clap

    clap Member

    22
    13
    1
    I have changed something my original post, I have changed my stock air box to a stage 1 air air set up . What settings should I start with now or will it be the same as what Dobeck tech, posted
     
  10. Rubyred

    Rubyred Senior Member

    1,020
    48
    11
    I started with what they recommended (shown above). It works fine for me. Ride it for a while and if not satisfied call Dobeck again. They get lonely out there.:)