JAGG oil cooler

Discussion in 'Touring Models' started by Gabbin, May 10, 2014.

  1. Gabbin

    Gabbin Member

    15
    0
    0
    Does anyone know what the fan switch should ohm out at? I'm getting no reading?:(

    I fear I may have damaged it during the install of the cooler, when I tied in to the brake switch, I blew the accessory fuse.
     
    Last edited by a moderator: May 11, 2014
  2. Bodeen

    Bodeen Well-Known Member Staff Member Moderator Contributor

    4,316
    73
    130
    It's a simple switch, its either open or closed. Reading across the pins with an ohm meter its either 0 or switch closed, infinity or switch open. The possibility exists that the one pin or the other is going to ground and that would be one lead to a pin and the other to the side of the switch, then the other pin to the side of the switch. An y reading at all here is voltage going to ground = bad news.
     
  3. Gabbin

    Gabbin Member

    15
    0
    0
    Well, that was the case, I replaced the fan switch with a 180* switch, since the oem was damaged. It runs perfectly. Thanks Bro!
     
  4. Bodeen

    Bodeen Well-Known Member Staff Member Moderator Contributor

    4,316
    73
    130
    Excellent!