ISR switch clamps on an 08 Fat Bob

Discussion in 'Electrical' started by O8FatBob, Oct 31, 2013.

  1. O8FatBob

    O8FatBob New Member

    1
    0
    0
    Looking to clean off the factory switch blobs and I really like the ISR switch clamps and hand controls. I've been searching and reading whatever I could find, but I can't quite figure what needs a relay and what doesn't. As best I can tell, the horn will require a relay to run off the 25 milliamp switch but have not found anything about the kill switch. The signals should be fine from what I've seen and the hi-lo and the on-off should work fine off the 6 amp sliders. Any confirmation/redirection is welcome.

    Lastly, once I figure out what needs relays, where is the best place to physically locate them on the bike for the cleanest and most effective install?

    Thanks for any words of wisdom.