ISO Grips on a 2008 Ultra

Discussion in 'Touring Models' started by hogcrzy, Jul 18, 2008.

  1. hogcrzy

    hogcrzy New Member

    1
    11
    0
    Shouldn't be too difficult, just wondering if anyone can tell me what this note on the package means: "WARNING-Please insure that you keep the glue from the throttle open"

    Maybe it lost something in the translation.
     
  2. glider

    glider Veteran Member

    25,464
    108
    43
    No doubt it has something to do with the drive by wire maybe being an 08? Isn't there more?

    Check their web page, they have the directions posted there usually, maybe the didn't print right.
     
  3. Bud White

    Bud White Well-Known Member Retired Moderators

    3,270
    48
    2
    i would think it would be throttle opening is what ti would say .. since the drive by wire would glue where the stuff is
     
  4. Rebyl

    Rebyl Banned

    98
    0
    0
    I have just ordered some and the intructions say that you only use the glue on the left. Check the instructions it says, "Throttle Side Procedure", then tells you what to do, it gives you five steps and then tells you what to do with the left hand side, with eight steps. If instructions in the pack do not say the same, go to the Kuriakyn site and click on product #6228 and download fitting instructions...simple as
     
  5. MikeMihelich

    MikeMihelich Member

    14
    11
    0
    I put on the harley grips and can't see why you'd want to glue either side. Both grips are held in place by the switch housings. Just my .02
     
  6. Bud White

    Bud White Well-Known Member Retired Moderators

    3,270
    48
    2
    I wanted a set of ISo grips till i found out they are not held in place on both sides the same way as the harley grips ... So ill find something in the harley line
     
  7. The Bad Man's Angel

    The Bad Man's Angel Active Member

    112
    26
    0
    Stock HD left grip is glue on. don't sweat it just fellow the instructions and you'll be fine.
    To get the original stock grip off without cutting it slid a small flat bladed screw driver between the grip and bar and spray some WD40 into the opening, work with it twist back and forth and use more WD40 as needed and it'll come right off.
    To remove the ISO grip remove it's end cap and use the same method as for the stock grip.
    The ISO grips are great, i use them and the ISO foot pegs.
     
  8. dan1551

    dan1551 Account Removed

    49
    16
    0
    I have the ISO grips on my 08 ULTRA. before you glue the left one make sure you have it rotated to where you want it .( put it on with no glue rotate it for comfort the take it off and glue it . ) By the way I LOVE THEM!
     
  9. Wardster

    Wardster Member

    6
    11
    0
    I installed the ISO grips on my '08, but ended up using gorilla glue on the left side after the glue that came with them failed.

    -Wardster