Inner Primary Removal?

Discussion in 'Dyna Models' started by ~PK~, Aug 8, 2010.

  1. ~PK~

    ~PK~ Member

    78
    6
    0
    Im have a tough time with this one... everything besides the chain tensioner bolts are removed...including the starter. What else do i need to do?

    Thanks,

    Paul
     
  2. bwalsh22

    bwalsh22 Junior Member

    756
    28
    3
    Sounds to me like you got everything, might just need a bit more of a wiggle, or you are missing a bolt somewhere. That is usually my problem. One lone, hidden bolt.
     
  3. Breeze3at

    Breeze3at Well-Known Member

    4,643
    83
    123
    The last person to assemble it may have used an adhesive to seal it. Use a rubber mallet (or block of wood) to tap all around it many times. Does it wiggle at all, or solid all around? Any starter bolts still in? I run a open belt primary on my shovel, so I can't remember if the rotor has to be pulled to get the inner off, but it seems like I didn't.
     
  4. ~PK~

    ~PK~ Member

    78
    6
    0
    I can see alittle bit of play in the front so i know its atleast loose to a point. Ill try your method and see what happens!

    Thanks Guys,

    Paul
     
  5. TQuentin1

    TQuentin1 Well-Known Member Staff Member Moderator

    4,630
    68
    99
    Inside the primary behind where the clutch basket was you have at least three bolts, a couple more towards the compensator, plus two at the front outside the primary cover, right? All those are out, right?

    TQ
     
  6. ~PK~

    ~PK~ Member

    78
    6
    0
    Done

    Its off now...took a 2 x 4 and wrapped it in a towel and tapped the back from the other side and it fell off :)

    Thanks Guys,

    Paul