how do you remove

Discussion in 'Engine, Fuel and Exhaust' started by 67shovelbucket, Mar 23, 2012.

  1. 67shovelbucket

    67shovelbucket Banned

    50
    0
    0
    the S&S oil pump from a pan shovel case , I have to front half off but i cant get the rest to let go what am I doing wrong?
     
  2. tourbox

    tourbox Senior Member

    1,182
    58
    36
    There is a retainer ring on the end of the pump drive shaft. The back part,with the gears in it,should just pull off after removing ring. As you're looking at the 2 front gears,the one on the left is keyed to the shaft,one on the right is like an idler gear and will slip out. Same for the 2 gears on the back side. There is the drive gear inside the gear cover, where cam is at, it also has a retainer ring.It keeps the shaft from coming out of the motor/gear case. You have to allign the pump for no drag when reinstalling. Good luck
     
  3. Jack Klarich

    Jack Klarich Expert Member Contributor

    17,441
    123
    153
    Check the bushing for wear, do not mix and match any of the oil pump gears:D