Help

[seawall]

So got the new bike...Wanted some new bars-and the fun begins...I extended the original cable harness (clutch and throttle side) and I cannot get the rear lights to behave...One is brighter than the other, and only one signal works. All lights in front and other functions good to go.

No wires are crossed, all fuses good to go, ground is grounded...I am really confused...Thanks in advance

Any ideas?

 

[stray dog]

For fun try switching rear running bulbs around.

You sure no wires crossed? Were you disassembling/assembling plugs during your wiring harness project? Check pins properly seated in them..??

 

[seawall]

So just got back in from the garage, dinking with the deal. Thought I would check the bulbs...One does have an element that is broke. However that is the one that is working (on high) and the other with two good elements does not work in either of the signal's?

Thanks for the advice, I will get two new bulbs and see what happens. Yes, I did take the plugs apart...I will check those again after I get the new bulbs. Hope that's the deal. Appreciate the advice...