HD LED run/stop/turn signals problem

Discussion in 'Other Service and Maintenance' started by eodhandyman, Aug 5, 2014.

  1. eodhandyman

    eodhandyman New Member

    Let me start off with what I have: 2008 Heritage Softail Classic with all HD LED lighting (headlight, auxiliary, turn signal, fender tip, tail). I first replace the rear turn signals with HD 68128-10 Bar & Shield Rear LED Turn Signals in 2011. I had the right light burn out (possible blown capacitor) in 2012 and replaced the right side. The right side again has blown with no lights working on that side (brake/run/turn). I replaced it with the extra light that I had and everything is working fine. My dilemma is, has anybody had any issues with this light and if so, what was the fix? I would hate to have to replace the entire light every couple of years with what HD is asking for them. HD Techs are of no help. Thanks in advance for any suggestions/help.
  2. Jeff Klarich

    Jeff Klarich Well-Known Member Contributor

    Going to LED'S did you add a load equalizer to your system?
  3. dbmg

    dbmg Experienced Member

    Or have you checked connections especially the grounds. I believe that LED lights do not with stand erratic changes in voltage very well.