Harley Changes

Discussion in 'General Harley Davidson Topic' started by glider, Dec 23, 2011.

  1. glider

    glider Veteran Member

    25,464
    108
    44
    What's the ONE thing you would change about the way your bike was made, an improvement or just something that bugs you about it.
     
  2. Gas Gauge

    Gas Gauge Junior Member

    434
    28
    11
    the location (and orientation) of the oil filter....

    ....come on man!
     
    1 person likes this.
  3. glider

    glider Veteran Member

    25,464
    108
    44
    It sure would be nice if it was upright too so the oil doesn't run all over the bike when you loosen it up.:D
     
  4. Davidw2415

    Davidw2415 Senior Member

    1,456
    46
    0
    It would be nice if the shocks on softails didn't extend below the frame so that there would be no need to use frame protectors when using a jack to left the bike.
     
  5. Redfish-Joe

    Redfish-Joe Senior Member

    2,307
    48
    10
    I would like to see the out sourcing of parts stop. Put Americans back to work.
     
  6. 1Canuck

    1Canuck Banned

    47
    0
    0
    build with the updated parts and stop saying "that is normal they all do it" when the heavy duty parts can be purchased, like the SE compensator, SE clutch spring etc.
     
  7. rhino 2

    rhino 2 Active Member

    182
    0
    2
    Automatic [on board] air compressor for the rear shocks on the TG
     
  8. trike lady

    trike lady Junior Member

    513
    28
    6
    I agree with that.

    More trike models
     
  9. Bob Kennedy

    Bob Kennedy Member

    21
    0
    0
    1. Put on mirrors that give you a view of what's behind you. The only thing I could see in the stock mirrors was my elbows.

    2. Ditch the dual turn signal buttons for a single button on the left bar.

    3. Outsource parts to Slovenia. Put Slovenians back to work! :naughty
     
  10. fin_676

    fin_676 Experienced Member Staff Member Moderator Contributor

    5,276
    133
    156
    Relocate the side stand on the dyna to a similar position to the other models so that i can easily find it without having an extension on it
    get the sump out of the way so that i can use a lift without having to use adaptors
    move the turn signals control to 1 button on the left side

    Brian